Borehole Yield Too Low

A low-yield borehole cannot sustain the flow being demanded. Pulling more water than the borehole can recover will cause failure.

What you’ll usually notice

You may notice: – flow dropping after a few minutes – pump tripping on dry-run protection – inconsistent supply

What’s normally behind it

This usually happens when demand exceeds natural recovery. Typical causes include: – seasonal water level changes – oversized pump – overuse of the borehole

Why quick fixes don’t stick

Installing a larger pump worsens the problem and increases risk.

How this is normally handled

Water Usage Monitoring & Metering

This service diagnoses the real cause and fixes the system properly, not just the symptom.

What actually fixes it

This problem is normally handled by working within the borehole’s actual yield.
Storage and control strategies are used to match demand to supply.

What you can check yourself

You can check a few things yourself:
– measure how long flow lasts before dropping
– compare performance across seasons

When to call someone in

If the system is regularly running dry, the borehole needs to be managed correctly.

When should I call a water system professional?

You should call a professional when problems repeat, systems behave unpredictably, pumps fail regularly, or when you need clarity before making costly system changes.

Why does my borehole water look dirty or sandy?

Dirty or sandy borehole water usually indicates poor borehole development, pump placement issues, or the need for proper sediment and media filtration.

Why do filters block so quickly?

Filters blocking quickly is often due to incorrect filter selection, unexpected water quality issues, high sediment loads, or lack of staged pre-filtration.

Why is my water pressure low?

Low water pressure is usually caused by undersized pumps, incorrect pressure settings, pipe restrictions, or supply limitations from municipal, borehole, or tank-fed systems.

Why does my pump keep switching on and off?

Rapid pump cycling is typically caused by pressure tank issues, incorrect pressure switch settings, leaks, or pumps that are oversized for the system demand.