Borehole Pump Pulled and Inspected

If borehole performance drops over time, it usually means internal wear, scaling, or damage inside the pump or column pipe. The only way to confirm this is to physically inspect the system.

What you’ll usually notice

You may notice: – reduced flow compared to when the system was installed – the pump sounding strained or working harder than usual – visible corrosion or aging at the borehole headworks

What’s normally behind it

This usually happens over time as components wear or become restricted. Typical causes include: – mineral buildup inside pipes and pump stages – sand erosion on impellers – aging electrical or mechanical components

Why quick fixes don’t stick

Replacing surface components without checking the downhole equipment often misses the real cause of the problem.

How this is normally handled

Water Usage Monitoring & Metering

This service diagnoses the real cause and fixes the system properly, not just the symptom.

What actually fixes it

This problem is normally handled by safely extracting the pump and inspecting the full assembly.
Each section is checked, and the motor condition is tested before deciding on repair or replacement.

What you can check yourself

You can check a few things yourself:
– compare current flow to original system performance
– check installation records for pump depth and age

When to call someone in

If the system is over five years old or performance has dropped significantly, a full inspection may be required to prevent failure.

Why does my borehole water look dirty or sandy?

Dirty or sandy borehole water usually indicates poor borehole development, pump placement issues, or the need for proper sediment and media filtration.

Why do filters block so quickly?

Filters blocking quickly is often due to incorrect filter selection, unexpected water quality issues, high sediment loads, or lack of staged pre-filtration.

Why is my water pressure low?

Low water pressure is usually caused by undersized pumps, incorrect pressure settings, pipe restrictions, or supply limitations from municipal, borehole, or tank-fed systems.

Why does my pump keep switching on and off?

Rapid pump cycling is typically caused by pressure tank issues, incorrect pressure switch settings, leaks, or pumps that are oversized for the system demand.

When should I call a water system professional?

You should call a professional when problems repeat, systems behave unpredictably, pumps fail regularly, or when you need clarity before making costly system changes.