← Back to Pressure & Pump Problems

Electrical Surge or Lightning Damage

Power surges can damage both control electronics and motor windings. The system may fail suddenly after a surge event.

What you’ll usually notice

You may notice: – system completely dead – burnt smell near controls – earth leakage tripping

What’s normally behind it

This usually happens due to unstable power supply. Typical causes include: – lightning strikes – grid switching events – lack of surge protection

Why quick fixes don’t stick

Replacing fuses does not resolve underlying electrical damage.

How this is normally handled

Water Usage Monitoring & Metering

This service diagnoses the real cause and fixes the system properly, not just the symptom.

What actually fixes it

This problem is normally handled by testing damaged components and installing surge protection to prevent recurrence.

What you can check yourself

You can check a few things yourself:
– confirm if other equipment was affected
– note timing relative to storms or outages

When to call someone in

If the system failed after a surge, electrical inspection is required before restarting.

Why does my pump keep switching on and off?

Rapid pump cycling is typically caused by pressure tank issues, incorrect pressure switch settings, leaks, or pumps that are oversized for the system demand.

When should I call a water system professional?

You should call a professional when problems repeat, systems behave unpredictably, pumps fail regularly, or when you need clarity before making costly system changes.

Why does my borehole water look dirty or sandy?

Dirty or sandy borehole water usually indicates poor borehole development, pump placement issues, or the need for proper sediment and media filtration.

Why do filters block so quickly?

Filters blocking quickly is often due to incorrect filter selection, unexpected water quality issues, high sediment loads, or lack of staged pre-filtration.

Why is my water pressure low?

Low water pressure is usually caused by undersized pumps, incorrect pressure settings, pipe restrictions, or supply limitations from municipal, borehole, or tank-fed systems.